After clearing the other alarms and replacing the battery, set parameter #2049 back to its original value and go through the zero point setting procedure.

You won't be able to do a tool change until you turn the absolute back on, though. Make sure you make a note of what value this parameter is set to before changing it. This should allow you to move the axis so that you can check that the machine is otherwise OK.

Harri, You can turn off the absolute mode by setting parameter #2049 to '0' for all axes. Also, is there a way to back up parameters to memory card or by RS232?Ĭheers, Harri. Any thoughts or tips about setting the zero points would be greatly appreciated. It doesn't go into MPG mode, which means I can't do the zero point adjustment. The machine also refuses to move the axes, swap pallets or do tool changes. Also note that you are able to contact the dealer from whom you purchased the product for assistance, in.Īny ideas on what I should use as the reference table? The machine is with APC, and the manual isn't very helpful. uk Operator’s Manual user manual, maintenance instructions and spare parts CS45 / CS50 Keep this manual handy so that you may refer to it later whenever any questions arise. Lost Parameters on Meldas 50 - Download as Word Doc (.doc /.docx), PDF File (.pdf), Text File (.txt) or read online. Z axis zero point should be set with a 250mm gauge block between the spindle nose and table, not subtable. The manual says that these need a new zero point adjustment, and I have the procedure detailed in the manual. It comes up with the following errors: Z70 'ABS illegal Error' 0101 XYZ2 M01 'Operation error' S52 Servo Alarm Oil Pressure low (Machine Mori Seiki TV-30 APC, MSC 802/Meldas 50M) I'm unfamiliar with the Meldas Control and somewhat stuck. The machine was fully functional but lost the absolute positioning after backup battery failure. Hi everyone, I'm having some trouble with my 'new' Mori TV-30.

Meldas 50 operators manual